You are measuring far below the specified range of the attenuators at
7-16.5 GHz. At least that is per your description.
*Clyde K. Spencer*
переключити цитоване повідомлення
Показати цитований текст
On Tue, Aug 24, 2021 at 6:43 PM Mike C. <mg@...> wrote:
Hi All,
New to the group. I have a SAA-2N w/N connectors and cal set. With the
necessary adapters (SMA to N etc..) I am not sure I understand if my
measurements are correct. Measured (stimulus) from 1MHz - 100MHz;
calibrated w/cal set. I then connected a 30db attn and it reads -25.6db
@ 30MHz, what is going on? Note: this attn is marked 7-16.5GHz and is an
SMA. (I have many of these attenuators and several tests on various
units produces nearly the same results)
Mike C.
