1. Nanovna-Users
  2. Повідомлення
Одинарний Повідомлення Теми Розширений

Re: Measuring Attenuators

 

I want to thank all of you for your inputs as I've learned many things in this short time. I'll run a few more attenuators only under narrower freq limits and put the results on my page for easier viewing. It'll be a couple of days, gotta get the car fixed tomorrow.

Mike C.

On 8/25/2021 7:35 PM, David Eckhardt wrote:
Attenuators should be measured with the same setup and philosophy as
filters. They should be placed in a "THRU" or transmission measurement
configuration. One could measure them in strictly a reflection manner
assuming the reflection at the far unterminated or shorted end is 100%, but
the errors will be greater than in the transmission mode. Measured in the
reflection mode, the displayed attenuation will be twice the actual
attenuation.

Dave - WØLEV

On Wed, Aug 25, 2021 at 6:26 PM Donald S Brant Jr <dsbrantjr@...>
wrote:

Mike: You ARE looking at S21 and not S11, right? What does a thru look
like?
73, Don N2VGU
Приєднайтеся до {nanovna-users@groups.io, щоб автоматично отримувати всі повідомлення групи.