On Thu, Jun 15, 2023 at 07:59 PM, Steve Kuehn wrote: So if a reboot does not take care of it, it is probably RMA time. I wouldn't say that at all. Worth checking REPORTCRESNET and/or NetDevTree to ens

I have tried using the same phase for all channels and using two separate phases for channels 1-4 and 5-8. Neither seem to work. It's like channels 5-8 are somehow blocked/protected electrically.

Add ch processor and then import signals from Simpl windows into crestron home. Nf NFH

Is there a HOME driver for VANTAGE? The problem is we have both HOME and SIMPL projects underway, so we need modules that can play with both. I've already asked Shelly if they plan on releasing DIMMER

You can wrap an oscillator in a standard SIMPL module and load it into D3pro as a logic module - hooking it up in D3 is a faff, but that would be how I’d do that (off the top of my head)

Thanks guys I will give it a try.. anyway I don’t think it will resolve the issue because the issues occurs after a program restart and the router is definitely up and running. De: crestron@groups.io

Is there an easy way to have D3Pro restore all lights to the levels they were right before a reboot/restart/new program load, etc.? For example, if owner is in utility room with fluorescent lights on,

Try configuring in Studio or using Engraver

Hi i am having an issue with the dali driver of led strip, It shows failure when addressed on the dali commissioning tool but i can control the intensity of the light . But when i add it to a group fo

The one thing that can sometimes trip people up with this method is when the lights get dimmed to zero. If this happens, then zero is the new scene level. The next time the scene is recalled, the ligh

David, Colorbeam is a low-voltage, DMX based lighting system that supports tunable white and RGB. We've used Colorbeam products with success, but not with Crestron Home yet. There was a Colorbeam driv

I have a client where CLX keypads were replaced with Horizon, installed and ID'd by tech onsite. I have remote access and was hoping to now enable the backlight/feedback via D3Pro and send program ove

Ah, I see. I noticed with bracket installed, the keypad does not sit on sheetrock, and has a little less than 1/16" gap, while the keypad with no bracket sits right on the sheetrock. Thanks for the re

I can help you on LiteTouch 2000 and Compaq systems, programming, integration, repair, etc.

Mh, i think it was early 2019 for me…. Cheers, Thorsten Von: crestron@groups.io <crestron@groups.io> Im Auftrag von dblpnt Gesendet: Freitag, 8. Oktober 2021 16:30 An: crestron@groups.io Betreff: Re:

Keen! I must've gotten stuck thinking of making a ABUF work when I should've been looking at ARAM. Thanks for the pointers!

The EX-P come with a complete set ofbittons for all possible combinations.

If you run into problems I can help figure out what is going on and update the module so it will work for you. Let me know how it goes Thanks Jay

For the most part, I prefer to use the CEN-GWEXER over the build in MC3 gateway. The main reasons are: 1) The CEN-GWEXER has a build in WIFI scanner that will tell you what the interference is on any

I have had the license just invalidate itself on the only 2 projects that I am interfacing with lutron. Open license management and you will see the installed license. Open text console with the proce