clients are impatient tap screen, nothing happens, tap again, finally wakes up & back to project select is there any way to keep the connection active? i know battery life will suffer

i had to rebuild a prodigy system from scratch the composer locks 3 buttons on the keypads, top is on/off, bottom 2 are vol +/- problem is that the vol+ button doesn't have any code in the OLD days wh

it appears to load the project into portrait mode as the panel boots, i see the crestron logo large, then smaller, then it flips to portrait with the crestron logo with the dots below so even the inte

LCDORIENTATION says updating to landscape, reboot, still portrait however, setting it to portrait set it back to landscape... well, the ch5 project was fine, however, now it thinks it is a TSW-770P an

i loaded a construct project for a 1080 into my 770, the TP switched to portrait mode i reloaded my original project - still portrait haven't found a way to set it back?? reloading firmware did NOT fi

i'm starting to look at AVStudio - i find it much more straight forward than Construct no knowledge of HTML required, but a little knowledge does help start here Follow Up Webinar there have been 2 wo

did you just send text msgs with SIO, or write a module i don't know if i'm doing anything other than presets??

FCS Commands

we learned the codes, got some from Global Cache but, cursor commands, channel up/down still repeat badly (replaced ch +/- wirh GC codes) this is with an HR-150 another site with same IR driver and ha

client has changed TV boxes, need original pgm

i guess both work, is there a reason to use 1 or the other?

looking at using VIDEO.CEC_GENERIC to control the displays anyone used this? not much in the docs am i just sending ascii i.e. "40446D" for PowerOn_RCP

thanks!

still no reply anyone have the API to post? i have a module for decoding, but looking at something for the encoder - need hotsync for tabletop connection the decoder just takes an IP address, just sen

not sure if this may help the MC3 3-Series® and PYNG-HUB Processors: Offline in MyCrestron Residential Monitoring Service (RMS) sorry, no - just loaded up an MC3, updated certificate, rebooted, authen

the app can see my PYNG-HUB, but i can't connect with SSH do i have to setup authentication for it to work?

i have had the beta for about a month now - Pixel 8 Pro it works with all the restrictions mentioned above afraid to update to the official version

i just took a peak & almost all the processors i monitor are offline. All say this occurred 4 months ago for each of them. Quite a coincidence i would say. Anyone else seen this?

i have the beta - works OK

i emailed them yesterday for Crestron modules, nothing yet...