This exact thing happened to me on a laptop I'd been using for three years, maybe two months ago. It was after a Windows update. I rolled back but that didn't fix it. Spent a decent chunk of time on w

Ahoy! Has anyone done any comms with a Poly hardware via the REST API? I'm having a hard time figure out how to deal with authentication. Specifically trying to make some config changes on-the-fly for

Anybody ever run into problems using the HD-EXT-USB-2000-C with a Flex system? Engine is on the TX side to get HDMI video to the display (Engine HDMI > Tx HDMI > Rx HDMI > Display HDMI). Logitech PTZ

I don't have a module but recently worked with one of these. Behaved just as expected based on the protocol. PM me if you can't get your hands on it.

Yes, forwarding Port 61415. However, this only works if you have a single DSP on the subnet. If you've got multiple FORTEs or a SERVER and a FORTE, etc., the software will complain that it can't conne

I did one recently. The protocol is super simple. I wasn't doing that much with it so I didn't bother wrapping the symbols in a module.

I noticed this recently. Also 4kz endpoints. Close to a full second between making a route -- either programmatically or directly in the web GUI -- and the signal actually switching.

Yes I got them working, but only in standalone mode. They will be managed via FG, so hopefully that doesn't end up breaking things. I anticipate more trial and error when on site with the customer's g

Anybody put NVX endpoints on Fortinet switches? I believe they meet spec but I'm not looking forward to diving into their GUI and/or CLI. Crossposted to the Facebook group.

There was a long thread (in the old Yahol group) on the 701 just a few weeks ago. Similar weirdness. I believe some folks were able to find a solution. Might be worth checking out.

Check the DNS settings in the AV3 too.

I believe I've used hostnames with the 3.0 modules. Are you able to SSH or telnet to the units direct from your laptop, using hostnames, while on that network? Does the processor get a response when a

I typically enable a blank page via a 30s one-shot. The page clears when the one-shot expires. Make sure to buffer the hard buttons too, so that they don't do anything when the cleaning page is active

Don't you need the ID to get feedback? Or is that no longer the case?

No carriage returns or line feeds for MDC Samsungs. Checksum should be the final byte. Power On: \xAA\x11\x01\x01\x00\x13 If that doesn't work I'd try that command direct from your laptop, bypassing t

What is the AM-200 getting its calendar info from? You'd need logic to connect to the same server and parse the data. We've done it for Exchange (custom) and Fusion (using Crestron's SSI modules).

I do the same. 0 = Off 1 = Dim 2 = Bright (default)

Awesome, thanks. Related: can I plug up an SSW-102 via USB and get the same red/green behavior as if I had the scheduler firmware? Or do I need go control the SSW via Cresnet?

Ahoy, Has anybody used the Scheduling Application on a TSW panel? Not the firmware that you load to a panel to turn it into a pure scheduling panel, but rather the widget you drop into a VTP project t

Lincoln, are you saying that Tesira network command strings transmit both on the control network port and the Dante port? That's the only way I see that working, as a device like the MXAs only has one