I have replaced power supplies in a few PAC2M units. They are failing due to age. Replace the power supply with a LPS65. You can purchase one from Mouser Electronics: https://www.mouser.com/ProductDet

I am away from work PC but the commands are from Crestron's help pages if you search CEC commands. When I press any of the navigation keys it wakes up the NVidia Shield. Yes the menu works. I use it t

If you are using a Crestron DM system... I use standard CEC commands and they work great! Play, pause, FF, Rewind, navigation all work.

If your CISCO switch supports this, try to enable "Storm Protection" on the IGMP Querier. This fixed this problem on a job - same symptom, network goes down every few minutes.

Has anyone written a CEN-ODT-C-POE into a Simpl Sharp Pro program? The only class I can find is the GlsOdtCCn Class but it mentions "Occupancy Sensor that resides on the Cresnet bus for the specified

Just worked on QM65 and had issues using normal commands to control. Ended up setting unit to ID 01 and these commands worked: Power on: \xAA\x11\x01\x01\x01\x14 Power off: \xAA\x11\x01\x01\x00\x13 Po

I switched over to 4.14.21 over a week ago - so far so good for everyday use! The only thing I noticed is font sizing changed in SIMPL+ and some minor cosmetic changes in SIMPL. I figured they worked

The Epiphan cameras use standard VISCA so a module for any Sony camera should work. I used a Sony EVI-D100 and it worked, even using presets. -Greg.

No I cannot register for USA yet either :-(