I'm guessing you are connecting to the Marantz and staying connected. For some reason if you are connected to the Marantz when Crestron reboots, Crestron can not reestablish the connection until the s

I have a problem with the ip control of the Marantz with any crestron processor I use. I am using the module for control via serial command via IP and every now and then (I have not been able to under

What kind of output does the desired module need to have? Are we pushing to HDMI and displaying on a screen, or are we wanting to drive a narrow horizontal strip of LED’s with information crawling acr

Check message 22975 It was all the rage in 2004! Not sure if Chip has kept that one updated ;-)

Or does anyone know how to make one?

Hi Thor! Thanks for the reply. Yep, It seems the save as procedure, which I described above, for the 1070 did not work as I would have liked. Could you perhaps describe the steps to get the 1070 file

Hi, to be honest, i´m not completely sure I understand your problem. I understand the communication and control is working via Toolbox debugger, but not using your TP? I´m not sure if this is an issue

Hi Thorsten! Thanks for the reply. I originally and reverted to just using the Trinnov supplied 2.1.9, with absolutely nothing changed or added. After that would not show connected, nor work, from the

Hi, i´m usually not using the connect signal at all on the Trinnov module. It should work right away. Can you share your code? Which module version are you using? Cheers, Thorsten Von: crestron@groups

Hi All! Any help appreciated-seems I am missing something "Simpl." I have a Trinnov Alt 32, 4/23 build and a Pro4 with a 1070 panel. I can run all commands from debugger with good results, with a"'sav

I Have a Clipsal Dali Gateway for lighting control I need any method to integrate with Crestron Any Module except that found at the App Market

yes please post - Vista 128bpt is oldie but goodie that hangs around for long time thx gene

I have a Vista 128bpt in my home. I used the Paul Cupp authored Crestron modules from an eternity ago. I found that the feedback on the modules was sometimes delayed by up to seven seconds. I found th

Tony - I've got a few of these coming up and would appreciate RS232 protocol doc for troubleshooting - possibly writing own module?

Both SIMPL and Crestron Home available. Cheers, Thorsten Von: crestron@groups.io <crestron@groups.io> Im Auftrag von jucava via groups.io Gesendet: Mittwoch, 13. März 2024 00:02 An: crestron@groups.io

Out of curiosity is this a SIMPL module or a Certified Driver?

Hi, DM-XIO-DIR-160 stopped working after trying to upgrade from ver. 2.0001.0041 to 4.0.121 It said Firmware completed, pressed ok and it showed 50min remaining, after that it stopped working. When en

I think the Cresnet port -IS- available on a 3-series processor in Slave mode. Answer ID 5232 describes it, and I'm fairly certain I've done it before.

EISC for sure. I'd put only my button presses and feedback to the CP3, and do any lighting logic local to the mc3. I'm not sure you can use an eslave device's gateway, I know you can't use it as a cre

Your idea is the best, cresnet is about 38400 baus rate, super slow. You can also try the EISC but it will requiere having two running program and get things synchronized