Is there a way to load Panel Pro on Startup? Did not see it listed under Add / Perform Actions. Stephen Marler

Hi. WB Train 21 is meeting EB Train 22 at Rocky. Rocky has 4 detected blocks: East Switch, Main Track, Passing Track, and West Switch. The East Switch is lined for the Main and the West Switch is lined for the Pass. Train 21 arrives first and holds the Main. Train 22 follows and takes the Pass. When Train 22 hits the West Switch and the detector fires, the Block Value for the West Switch is erroneously set to 21. As Train 22 proceeds and hits the Passing track, its value also becomes 21. This continues after the meet as Train 22 proceeds east – the block values all show 21. The Pictures below illustrate the problem. The numbers in gold besides each block are Block Contents icons. Train 21 approaches WB and is lined into the Main track. Train 22 approaches EB and is lined into the Passing track. Train 21 hits the East Switch block. The East Switch block contents are now “21”. Train 21 hits the Main. The Main block contents are now “21”. Train 21 clears the preceding (Leyden) block. Train 21 clears the East Switch and stops. Train 22 hits the West Switch block. The West Switch block contents are now erroneously set to “21”. Train 22 continues onto the Passing track. The Pass block contents are now also erroneously set to “21”. Train 22 clears the preceding (Plain) block. Train 22 clears the West Switch and stops in the passing track. Both the Main and the Pass blocks now contain “21”. Happy to do further tests. Thanks. Robin Robin Becker San Diego CA

I recently upgrade my MacBook Pro to Sequoia and Decoder Pro would not communicate with my MRC Prodigy Advance Squared. I installed FTDI DDxx drivers and JAVA 11 and now I can write CVs using the programming track but it hangs up whenever I try to read a CV. Any help would be greatly appreciated. Chuck Gevaert cgevaert@...

I have a unique problem. I have a double crossover leading into a reverse loop with an auto reverse unit. The polarity is reversed on the opposite sides of the double crossoverswitch. There are four switch motors with two addresses, wired so that they will throw each pair will enable a crossover. All four turnouts are isolated from each other allowing the control of individual polarity. In order to control the polarity I have installed relays to reverse the polarity on the opposite half of the switch pair and turn off the track power to the turnout that are not I use to prevent shorting as the locomotive passes through. The system works great using two single crossovers manually. However now I am trying to create a transit through the switch it is not working. I have installed a double crossover into the Panel only to find it is throwing all four turnouts, leaving the switch without track power as the throwing of one pair cuts track power to the opposite pair. Is there any way to get JMRI to only throw the turnouts that are required leaving the others in the straight through position?

How do I stop a script that I started from the UI. Trying to learn, I kicked off the example “back a forth timed”, my points were not set correctly and it set the loco down a short siding heading for the floor. I killed track power in time, but could not find a way to kill the script. Thanks